qmk-dactyl-manuform-a/keyboards/db/db63
Ryan 5e3951b361
Remove NO_UART defines from config.h for V-USB boards (#8351)
2020-03-09 19:58:25 +00:00
..
keymaps/default [Keyboard] Add support for db63 hotswap rbg (#7771) 2020-01-04 17:04:49 -08:00
README.md [Keyboard] Add support for db63 hotswap rbg (#7771) 2020-01-04 17:04:49 -08:00
config.h Remove NO_UART defines from config.h for V-USB boards (#8351) 2020-03-09 19:58:25 +00:00
db63.c [Keyboard] Add support for db63 hotswap rbg (#7771) 2020-01-04 17:04:49 -08:00
db63.h [Keyboard] Add support for db63 hotswap rbg (#7771) 2020-01-04 17:04:49 -08:00
info.json [Keyboard] Add support for db63 hotswap rbg (#7771) 2020-01-04 17:04:49 -08:00
rules.mk [Keyboard] Add support for db63 hotswap rbg (#7771) 2020-01-04 17:04:49 -08:00
usbconfig.h [Keyboard] Add support for db63 hotswap rbg (#7771) 2020-01-04 17:04:49 -08:00

README.md

DB63

A 65% keyboard hotswap with RGB that runs ps2avrgb natively, with USB C, RGB underglow and backlight.

  • Keyboard Maintainer: QMK Community
  • Hardware Supported: DB63 (ATmega32A)
  • Keyboard layout

Make example for this keyboard (after setting up your build environment):

make db/db63:default

Flashing example for this keyboard (after setting up the bootloadHID flashing environment)

make db/db63:default:flash

Reset Key: Hold down the key located at K00, commonly programmed as Escape while plugging in the keyboard. (All backlight LEDs will flash which indicate the board is in bootloader mode.)

Tips: Another trick to enable the board in reset mode is using BootMapper Client->Options->Set Bootloader. (This is only available for the first time, before flashing QMK Firmware.)

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.