56 lines
2.0 KiB
Markdown
56 lines
2.0 KiB
Markdown
# DGK6X = Venus, Hades, Galaxy, etc.
|
|
|
|
This DGK6X code is shared between the ANSI variants of Venus, Hades and Galaxy keyboards.
|
|
|
|
* Keyboard Maintainer: [J-Sully](https://github.com/J-Sully) and [dkjer](https://github.com/dkjer)
|
|
* Hardware Supported: Durgod Venus, Hades or Galaxy board with STM32F070RBT6
|
|
* Hardware Availability: [Venus](https://www.amazon.com/dp/B07XFP5MMZ), [Hades](https://www.amazon.com/gp/product/B08562392T) and [Galaxy](https://www.amazon.com/Galaxy-75-Modular-Mechanical-Keyboard/dp/B08PDRD8MP)
|
|
|
|
## Instructions
|
|
|
|
### Build
|
|
|
|
Instructions for building the Venus, Hades and Galaxy firmware can be found here:
|
|
* [Venus](venus/readme.md)
|
|
* [Hades](hades/readme.md)
|
|
* [Galaxy](galaxy/readme.md)
|
|
|
|
### Initial Flash
|
|
|
|
For first Flashing from initial Stock's Firmware
|
|
|
|
1. Back up original Firmware Image:
|
|
- Unplug
|
|
- Short Boot0 to Vdd (See below)
|
|
- Plug In USB
|
|
- Make a Flash Image's Backup in case you wanted to restore the Keyboard to Stock's Image:
|
|
- Using dfu-util:
|
|
|
|
dfu-util --list
|
|
dfu-util --alt 0 --dfuse-address 0x08000000 --upload ${OLD_STOCK_BIN}
|
|
|
|
2. Flash the QMK Firmware Image.
|
|
- Put board into Bootloader mode, using the same method as when backing up the original Firmware (above)
|
|
- Here are a few options for performing the initial Flash:
|
|
- Using [QMK Toolbox](https://github.com/qmk/qmk_toolbox)
|
|
- Using dfu-util:
|
|
|
|
dfu-util --alt 0 --dfuse-address 0x08000000 --download ${NEW_QMK_BIN}
|
|
|
|
You can short Boot0 to Vdd by shorting R19 to C30 on the sides closest to the processor, as shown:
|
|
|
|
* Hades & Venus:
|
|
<img src="https://i.imgur.com/JwF7MeZ.jpg" width="520" height="571" alt="Shorting Boot0 to Vdd on Hades or Venus">
|
|
|
|
* Galaxy 75
|
|
<img src="https://i.imgur.com/b9eZG5T.jpg" width="520" height="571" alt="Shorting Boot0 to Vdd on Galaxy 75">
|
|
|
|
### Subsequent Flashing
|
|
|
|
For repeating Flashing you can use BootMagic:
|
|
- BootMagic Lite has been enabled with Assigned "Esc" key
|
|
- Unplug USB Cable
|
|
- Holding Esc Button
|
|
- Plug in USB Cable, Keyboard should be in ST-Bootloader state
|
|
|