831deac212 | ||
---|---|---|
.. | ||
keymaps | ||
rev1 | ||
rev2 | ||
info.json | ||
readme.md | ||
rules.mk |
readme.md
Piggy60
A gasket-mounted 60% in the style of the S7 Elephant.
- Keyboard Maintainer: The QMK Community
- Hardware Supported:
- Piggy60 PCB rev 1 (atmega32u4, atmel-dfu)
- Piggy60 PCB rev 2 (APM32F103CBT6, uf2boot) Check your PCB before flashing! Loading rev1 firmware on a rev2 PCB may result in a non-functional PCB which can only be recovered using a hardware programmer (e.g. an ST-Link V2)
- Hardware Availability: Group Buy took place between 2021-05-22 1600 UTC and 2021-05-25 1600 UTC on https://jackylab.com/. Rev 2 PCBs were provided during extras sales and as replacements.
Make example for this keyboard (after setting up your build environment):
make jacky_studio/piggy60/rev1:default
make jacky_studio/piggy60/rev2:default
Flashing example for this keyboard:
make jacky_studio/piggy60/rev1:default:flash
make jacky_studio/piggy60/rev2:default:flash
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Bootloader
Enter the bootloader in 3 ways:
- Bootmagic reset: Hold down the top left key and plug in the keyboard. This will also clear EEPROM/emulated EEPROM, so it is a good first step if the keyboard is misbehaving.
- Physical reset:
- Rev 1: Short the set of vertical holes on the third row, to the right of Caps Lock. These can be reached with tweezers after the board has been assembled.
- Rev 2: Near the MCU there are two square pads with a circle in the middle. This is an unpopulated footprint for a reset button. Short these two pads twice in quick succession.
- Keycode in layout: There is no key mapped to
QK_BOOT
in the pre-created keymaps, but you may assign this key in any keymaps you create.
Flashing
After entering the bootloader through one of the three methods above:
- Rev 1: The keyboard will appear as an Atmel DFU device. It can be flashed using the QMK CLI or QMK Toolbox.
- Rev 2: The keyboard will appear as a USB mass storage device named
MT.KEY
. If the CLI is unable to find this device, the compiled.uf2
file can be manually copied to it. The keyboard will reboot on completion with the new firmware loaded.