416af0171c
* Remove CORTEX_ENABLE_WFI_IDLE from the codebase. * Turn on CORTEX_ENABLE_WFI_IDLE by default. |
||
|---|---|---|
| .. | ||
| keymaps | ||
| ktr1010 | ||
| ws2812 | ||
| chconf.h | ||
| config.h | ||
| halconf.h | ||
| info.json | ||
| mcuconf.h | ||
| meridian.c | ||
| readme.md | ||
| rules.mk | ||
readme.md
ai03 x PrimeKB Meridian
- Keyboard Maintainer: Holten Campbell
- Hardware Supported: STM32F072CBT6
Compiling firmware and flashing
Enter bootloader
The DFU state in the bootloader can be accessed in 3 ways:
- Bootmagic reset: hold down the key at (0,0) in the matrix (usually Escape) and plug in the keyboard; or
- Physical reset button: press the button on the bottom of the PCB; or
- Keycode in layout: press the key mapped to
QK_BOOTif it is available (Escape key on layer 1 in the default layout).
Compile firmware
The Meridian PCB was delivered in two variants, equal in design but using different RGB LED models: one using WS2812 and another using KTR1010 LEDs. Both can be compiled using
make primekb/meridian/ws1812:default
make primekb/meridian/ktr1010:default
After compiling, enter bootloader in the PCB and flash the firmware using dfu-util or QMK Toolbox. For direct compile-and-flashing, put the PCB in DFU state and use
make primekb/meridian/ws1812:default:flash
make primekb/meridian/ktr1010:default:flash
VIA-supported firmwares are also available.
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.