9aaf1c26f0
User reported that CAPS lock Led state was inverted after soldering a LED to their board. LED_PIN_ON_STATE defaults to 1, so just swap to low. Flashed board and now CAPS LED reflects the actual state |
||
|---|---|---|
| .. | ||
| m80v2h | ||
| m80v2s | ||
| chconf.h | ||
| config.h | ||
| halconf.h | ||
| m80v2.c | ||
| m80v2.h | ||
| mcuconf.h | ||
| readme.md | ||
readme.md
Mode Eighty V2 PCB QMK firmware
The Mode80 is a tenkeyless high-end keyboard sold by Mode Designs.
- Keyboard Maintainer: Gondolindrim
- Hardware Supported: proprietary PCB using STM32F072 controller
- Hardware Availability: you can get a Mode Eighty as of today (dec. 2021) through the in stock sales or special groupbuy editions at https://shop.modedesigns.com/
How to flash
Enter bootloader
The DFU state in the bootloader can be accessed in 3 ways:
- Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
- Physical reset button: press the button on the front of the PCB, next to caps lock, for at least five seconds
- Keycode in layout: Press the key mapped to
QK_BOOTif it is available (ESC key at layer 1 in the default layout)
Compile firmware
After accessing the DFU state in your PCB, build the default layout using:
make mode/m80v2/m80v2h:default # Hotswap
make mode/m80v2/m80v2s:default # Soldered
Then download the resulting binary *bin file using dfu-util or QMK Toolbox.
Compile and flash
After accessing the DFU state in your PCB, you can compile-and-flash automatically usind dfu-util through
make mode/m80v2/m80v2h:default:flash # Hotswap
make mode/m80v2/m80v2s:default:flash # Soldered
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.