ebb512db82
* Clean up `DEBOUNCE` in config.h, 0-9 * Clean up `DEBOUNCE` in config.h, A * Clean up `DEBOUNCE` in config.h, B * Clean up `DEBOUNCE` in config.h, C * Clean up `DEBOUNCE` in config.h, D * Clean up `DEBOUNCE` in config.h, E * Clean up `DEBOUNCE` in config.h, F * Clean up `DEBOUNCE` in config.h, G * Clean up `DEBOUNCE` in config.h, H * Clean up `DEBOUNCE` in config.h, handwired * Clean up `DEBOUNCE` in config.h, I * Clean up `DEBOUNCE` in config.h, J * Clean up `DEBOUNCE` in config.h, K * Clean up `DEBOUNCE` in config.h, L * Clean up `DEBOUNCE` in config.h, M * Clean up `DEBOUNCE` in config.h, N * Clean up `DEBOUNCE` in config.h, O * Clean up `DEBOUNCE` in config.h, P * Clean up `DEBOUNCE` in config.h, Q * Clean up `DEBOUNCE` in config.h, R * Clean up `DEBOUNCE` in config.h, S * Clean up `DEBOUNCE` in config.h, T * Clean up `DEBOUNCE` in config.h, U * Clean up `DEBOUNCE` in config.h, V * Clean up `DEBOUNCE` in config.h, W * Clean up `DEBOUNCE` in config.h, X * Clean up `DEBOUNCE` in config.h, Y * Clean up `DEBOUNCE` in config.h, Z * Remove default debounce from info.json * Migrate non-default debounce to info.json |
||
|---|---|---|
| .. | ||
| keymaps | ||
| config.h | ||
| info.json | ||
| matrix.c | ||
| readme.md | ||
| rules.mk | ||
| sixkeyboard.c | ||
| sixkeyboard.h | ||
readme.md
Techkeys SixKeyBoard
Keyboard Maintainer: QMK Community
Hardware Supported: Techkeys SixKeyBoard PCB
Hardware Availability: Techkeys
Make example for this keyboard (after setting up your build environment):
make sixkeyboard:default
See build environment setup then the make instructions for more information.
Hardware Info
The schematic is like this:
switches leds
,--+--+--. ,--+--+--.
|C7|B7|B5| |C6|B6|B4|
+--+--+--+ +--+--+--+
|D6|D1|D4| |D5|D2|D3|
`--+--+--' `--+--+--'
The LED on the bottom is C4. All 7 of the leds are turned on when the keyboard boots-up in the sixkeyboard.c file - backlight_enable is not required. The MCU is an Atmega16u2, so the flash memory is limited to 0x3000 bytes - the current setup uses just about all of that! I'm sure things can be opitimised a bit.
There is a jumper on the bottom of the board (next to the USB port) that serves as a reset button - I drilled a hole in my case to allow for quick access via a screwdriver/metal object.