* Clean up `DEBOUNCE` in config.h, 0-9
* Clean up `DEBOUNCE` in config.h, A
* Clean up `DEBOUNCE` in config.h, B
* Clean up `DEBOUNCE` in config.h, C
* Clean up `DEBOUNCE` in config.h, D
* Clean up `DEBOUNCE` in config.h, E
* Clean up `DEBOUNCE` in config.h, F
* Clean up `DEBOUNCE` in config.h, G
* Clean up `DEBOUNCE` in config.h, H
* Clean up `DEBOUNCE` in config.h, handwired
* Clean up `DEBOUNCE` in config.h, I
* Clean up `DEBOUNCE` in config.h, J
* Clean up `DEBOUNCE` in config.h, K
* Clean up `DEBOUNCE` in config.h, L
* Clean up `DEBOUNCE` in config.h, M
* Clean up `DEBOUNCE` in config.h, N
* Clean up `DEBOUNCE` in config.h, O
* Clean up `DEBOUNCE` in config.h, P
* Clean up `DEBOUNCE` in config.h, Q
* Clean up `DEBOUNCE` in config.h, R
* Clean up `DEBOUNCE` in config.h, S
* Clean up `DEBOUNCE` in config.h, T
* Clean up `DEBOUNCE` in config.h, U
* Clean up `DEBOUNCE` in config.h, V
* Clean up `DEBOUNCE` in config.h, W
* Clean up `DEBOUNCE` in config.h, X
* Clean up `DEBOUNCE` in config.h, Y
* Clean up `DEBOUNCE` in config.h, Z
* Remove default debounce from info.json
* Migrate non-default debounce to info.json
* Migrate `LAYOUTS` to data driven, 0-9
* Migrate `LAYOUTS` to data driven, A
* Migrate `LAYOUTS` to data driven, B
* Migrate `LAYOUTS` to data driven, C
* Migrate `LAYOUTS` to data driven, D
* Migrate `LAYOUTS` to data driven, E
* Migrate `LAYOUTS` to data driven, F
* Migrate `LAYOUTS` to data driven, G
* Migrate `LAYOUTS` to data driven, H
* Migrate `LAYOUTS` to data driven, handwired
* Migrate `LAYOUTS` to data driven, I
* Migrate `LAYOUTS` to data driven, J
* Migrate `LAYOUTS` to data driven, K
* Migrate `LAYOUTS` to data driven, L
* Migrate `LAYOUTS` to data driven, M
* Migrate `LAYOUTS` to data driven, N
* Migrate `LAYOUTS` to data driven, O
* Migrate `LAYOUTS` to data driven, P
* Migrate `LAYOUTS` to data driven, Q
* Migrate `LAYOUTS` to data driven, R
* Migrate `LAYOUTS` to data driven, S
* Migrate `LAYOUTS` to data driven, T
* Migrate `LAYOUTS` to data driven, U
* Migrate `LAYOUTS` to data driven, V
* Migrate `LAYOUTS` to data driven, W
* Migrate `LAYOUTS` to data driven, X
* Migrate `LAYOUTS` to data driven, Y
* Migrate `LAYOUTS` to data driven, Z
* disambiguate Bootmagic rules in keymaps
The files edited by this commit were added at a point in time where `BOOTMAGIC_ENABLE = yes` enabled full Bootmagic.
This commit edits the files to specify that full Bootmagic is intended.
* remove BOOTMAGIC_ENABLE=full setting
* unify commented BOOTMAGIC_ENABLE rules in keyboards
Explicitly sets `BOOTMAGIC_ENABLE = no` in keyboards where the rule was commented out.
Command:
```
find keyboards/ -type f -name 'rules.mk' -and -not -path '*/keymaps/*' -exec sed -i -e 's;#[ \t]*\(BOOTMAGIC_ENABLE\)[ \t=]\+\([a-zA-Z]\+\).*;\1 = no # Virtual DIP switch configuration;g' {} +
```
* remove commented Bootmagic rules from keymap/user level
Command:
```
find keyboards/ layouts/ users/ -type f -name 'rules.mk' -exec sed -i -e '/#.*\(BOOTMAGIC_ENABLE\)[ \t=]\+\([a-z]\+\).*/d' {} +
```
* update keyboard BOOTMAGIC_ENABLE rule formatting
Sets the formatting of BOOTMAGIC_ENABLE rules to `BOOTMAGIC_ENABLE = [value]`, without the inline comments (which will be replaced later).
Command:
```
find keyboards/ -type f -name 'rules.mk' -and -not -path '*/keymaps/*' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE\)[ \t=]\+\([a-z]\+\).*;\1 = \2;g' '{}' +
```
* update keyboards' BOOTMAGIC_ENABLE settings
Updates keyboard `rules.mk` files to use `BOOTMAGIC_ENABLE = lite` where `BOOTMAGIC_ENABLE = full` was being used.
Command:
```
find keyboards/ -type f -name 'rules.mk' -and -not -path '*/keymaps/*' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE = \)full;\1lite;g' '{}' +
```
* update keymap/user BOOTMAGIC_ENABLE settings
Updates keymap/user `rules.mk` files to use `BOOTMAGIC_ENABLE = lite` where `BOOTMAGIC_ENABLE = full` was being used.
Commands:
```
find keyboards/ -type f -name 'rules.mk' -and -path '*/keymaps/*' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE[ \t=]\+\)full;\1lite;g' '{}' +
find layouts/community/ users/ -type f -name 'rules.mk' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE[ \t=]\+\)full;\1lite;g' '{}' +
```
* remove and replace inline comments in keyboards and keymap/user files
Removes and replaces the inline comments, which have been updated to read `Enable Bootmagic Lite`.
Commands:
```
find keyboards/ -type f -name 'rules.mk' -and -path '*/keymaps/*' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE\)[ \t=]\+\([a-z]\+\).*;\1 = \2;g' '{}' +
find layouts/community/ users/ -type f -name 'rules.mk' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE\)[ \t=]\+\([a-z]\+\).*;\1 = \2;g' '{}' +
find keyboards/ layouts/community/ users/ -type f -name 'rules.mk' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE = lite\);\1 # Enable Bootmagic Lite;g' '{}' +
find keyboards/ layouts/community/ users/ -type f -name 'rules.mk' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE = yes\);\1 # Enable Bootmagic Lite;g' '{}' +
find keyboards/ layouts/community/ users/ -type f -name 'rules.mk' -exec sed -i -e 's;\(BOOTMAGIC_ENABLE = no\);\1 # Enable Bootmagic Lite;g' '{}' +
```
* rename improperly named makefiles
Some files intended to be used as makefiles had improper names causing them to not be used as intended when building.
This commit corrects the filenames of the affected files.
* update renamed file with new rule formatting
* update QMK's template files
Updates QMK's `rules.mk` templates to use the new inline comment.
* update QMK Docs
- remove documentation of full Bootmagic
- update links to Bootmagic Lite doc
- add doc for Magic Keycodes
* rules.mk patch for coarse/ixora and coarse/vinta
* Branch point for 2020 November 28 Breaking Change
* Remove matrix_col_t to allow MATRIX_ROWS > 32 (#10183)
* Add support for soft serial to ATmega32U2 (#10204)
* Change MIDI velocity implementation to allow direct control of velocity value (#9940)
* Add ability to build a subset of all keyboards based on platform.
* Actually use eeprom_driver_init().
* Make bootloader_jump weak for ChibiOS. (#10417)
* Joystick 16-bit support (#10439)
* Per-encoder resolutions (#10259)
* Share button state from mousekey to pointing_device (#10179)
* Add hotfix for chibios keyboards not wake (#10088)
* Add advanced/efficient RGB Matrix Indicators (#8564)
* Naming change.
* Support for STM32 GPIOF,G,H,I,J,K (#10206)
* Add milc as a dependency and remove the installed milc (#10563)
* ChibiOS upgrade: early init conversions (#10214)
* ChibiOS upgrade: configuration file migrator (#9952)
* Haptic and solenoid cleanup (#9700)
* XD75 cleanup (#10524)
* OLED display update interval support (#10388)
* Add definition based on currently-selected serial driver. (#10716)
* New feature: Retro Tapping per key (#10622)
* Allow for modification of output RGB values when using rgblight/rgb_matrix. (#10638)
* Add housekeeping task callbacks so that keyboards/keymaps are capable of executing code for each main loop iteration. (#10530)
* Rescale both ChibiOS and AVR backlighting.
* Reduce Helix keyboard build variation (#8669)
* Minor change to behavior allowing display updates to continue between task ticks (#10750)
* Some GPIO manipulations in matrix.c change to atomic. (#10491)
* qmk cformat (#10767)
* [Keyboard] Update the Speedo firmware for v3.0 (#10657)
* Maartenwut/Maarten namechange to evyd13/Evy (#10274)
* [quantum] combine repeated lines of code (#10837)
* Add step sequencer feature (#9703)
* aeboards/ext65 refactor (#10820)
* Refactor xelus/dawn60 for Rev2 later (#10584)
* add DEBUG_MATRIX_SCAN_RATE_ENABLE to common_features.mk (#10824)
* [Core] Added `add_oneshot_mods` & `del_oneshot_mods` (#10549)
* update chibios os usb for the otg driver (#8893)
* Remove HD44780 References, Part 4 (#10735)
* [Keyboard] Add Valor FRL TKL (+refactor) (#10512)
* Fix cursor position bug in oled_write_raw functions (#10800)
* Fixup version.h writing when using SKIP_VERSION=yes (#10972)
* Allow for certain code in the codebase assuming length of string. (#10974)
* Add AT90USB support for serial.c (#10706)
* Auto shift: support repeats and early registration (#9826)
* Rename ledmatrix.h to match .c file (#7949)
* Split RGB_MATRIX_ENABLE into _ENABLE and _DRIVER (#10231)
* Split LED_MATRIX_ENABLE into _ENABLE and _DRIVER (#10840)
* Merge point for 2020 Nov 28 Breaking Change
* add via keymap for doro67
* have more sensible VID and PID
* apply the same VIA changes to the regular PCB
* Update keyboards/doro67/rgb/keymaps/via/keymap.c
* Update keyboards/doro67/regular/config.h
* fix some formatting
* add via support for multi doro67
* Removed reference to firmware size in 0-9,a-f board-level and default keymap 'rules.mk' files
* Correct some 'rules.mk' in boards buried under vendor folders
* PR8027 patch
Co-authored-by: GeorgeKoenig <35542036+GeorgeKoenig@users.noreply.github.com>
Co-authored-by: James Young <18669334+noroadsleft@users.noreply.github.com>
* rename LAYOUT to LAYOUT_65_blocker_ansi
* rename LAYOUT macro
* enable LAYOUT_65_blocker_ansi community layout support and remove uneeded lines of code
* rename LAYOUT to LAYOUT_65_blocker_ansi
* rename LAYOUT macro
* enable LAYOUT_65_blocker_ansi community layout support
* enable LAYOUT_65_blocker_ansi support
* fix rename mess up
* add QMK Configurator support with the new rename
* rename blocker_ansi to ansi_blocker as it rolls off the tongue easier
Add spacing to LAYOUT macros, add layout comments, improve consistency, fix ISO layout bug
* Remove placeholder comments in regular.h and rgb.h
* Change K## to k## in multi.h and regular.h
* Add alignment whitespace in Doro67 LAYOUT macros
* Update multi default keymaps and add layout comments
* Update rgb default keymap and add layout comments
* Add RESET to Fn layer in multi default keymaps
* Replace KC_GESC with KC_ESC in rgb default keymap for consistency with other Doro keymaps
* Update regular default keymap and add layout comments
* WIP
* Replace odd F1, F2 with proper split LShift/Backspace keys in default_multi
* Minor fixes and tweaks in multi default keymaps
* Fix Enter and NUHS positions in multi LAYOUT_iso
* Return true in process_record_user in rgb default keymap
* Update Enter position in multi info.json
Co-Authored-By: noroadsleft <18669334+noroadsleft@users.noreply.github.com>
* Update labels in multi info.json to match the default keymaps
* Initial conversion of the rgb_led struct
* Converting last keyboard & updating effects to take advantage of the new structure
* New struct should not be const
* Updated docs
* Changing define ___ for no led to NO_LED
* Missed converting some keymap usages of the old struct layout
* initial commit
* get rid of some of the vanilla code
* set up matrix and pins
* Create LAYOUT macro and an appropriate keymap
* support for caps lock LED
* add some documentation to the doro67 parent readme
* align the language used in the several readme files
* initial commit
* get rid of some of the vanilla code
* set up matrix and pins
* Create LAYOUT macro and an appropriate keymap
* support for caps lock LED
* add some documentation to the doro67 parent readme
* align the language used in the several readme files
* Use RGB Matrix and fix enter key bug
* fix formatting
* remove merge conflict artifacts
* make a more useful default keymap
* add configurator support for the RGB pcb
* fix rgb matrix based on new info. Multipler should be reversed
* forgot to actually set the pin output for caps lock led
* fix offset keys in layer 1 keymap
* code cleanup
* use macros for the rgb_led calculations struct
* set RGB led num to 67 as I mistakenly counted the caps lock led
* cleanup config.h file
* add RGB note in readme
* get consistent naming in config file
* fix some inconsistencies
* readjust matrix and get rid of macros based on drashna's suggestions
Ryan
Nick Brassel
Joel Challis
Drashna Jaelre
James Young
MechMerlin
ridingqwerty
Konstantin Đorđević
XScorpion2
Daniel Peregolise