g1smo
/
qmk_firmware
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

Stabilize Half-duplex PIO split comms take 2 (#18421) 

...by moving the actually timing critical `enter_rx_state()` and
`leave_rx_state()` functions to RAM in order to not be affected by XIP
cache spikes. This commit also reverts the hacky USB interrupt disabling
that was done in 293c53d774
master
Stefan Kerkmann 2022-09-20 08:54:43 +02:00 committed by GitHub
parent ea90fccbd6
commit 881aab9e76
No known key found for this signature in database
GPG Key ID: 4AEE18F83AFDEB23
1 changed files with 2 additions and 15 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

17
platforms/chibios/drivers/vendor/RP/RP2040/serial_vendor.c vendored
View File

@ -140,9 +140,8 @@ void pio_serve_interrupt(void) {
// strength is chosen because the transmitting side must still be able to drive
// the signal low. With this configuration the rise times are fast enough and
// the generated low level with 360mV will generate a logical zero.
static inline void enter_rx_state(void) {
static void __no_inline_not_in_flash_func(enter_rx_state)(void) {
osalSysLock();
nvicEnableVector(RP_USBCTRL_IRQ_NUMBER, RP_IRQ_USB0_PRIORITY);
// Wait for the transmitting state machines FIFO to run empty. At this point
// the last byte has been pulled from the transmitting state machines FIFO
// into the output shift register. We have to wait a tiny bit more until
@ -162,11 +161,8 @@ static inline void enter_rx_state(void) {
osalSysUnlock();
}
static inline void leave_rx_state(void) {
static void __no_inline_not_in_flash_func(leave_rx_state)(void) {
osalSysLock();
// We don't want to be interrupted by frequent (1KHz) USB interrupts while
// doing our timing critical sending operation.
nvicDisableVector(RP_USBCTRL_IRQ_NUMBER);
// In Half-duplex operation the tx pin dual-functions as sender and
// receiver. To not receive the data we will send, we disable the receiving
// state machine.
@ -198,11 +194,6 @@ static inline msg_t sync_tx(sysinterval_t timeout) {
msg_t msg = MSG_OK;
osalSysLock();
while (pio_sm_is_tx_fifo_full(pio, tx_state_machine)) {
#if !defined(SERIAL_USART_FULL_DUPLEX)
// Enable USB interrupts again, because we might sleep for a long time
// here and don't want to be disconnected from the host.
nvicEnableVector(RP_USBCTRL_IRQ_NUMBER, RP_IRQ_USB0_PRIORITY);
#endif
pio_set_irq0_source_enabled(pio, pis_sm0_tx_fifo_not_full + tx_state_machine, true);
msg = osalThreadSuspendTimeoutS(&tx_thread, timeout);
if (msg < MSG_OK) {
@ -210,10 +201,6 @@ static inline msg_t sync_tx(sysinterval_t timeout) {
break;
}
}
#if !defined(SERIAL_USART_FULL_DUPLEX)
// Entering timing critical territory again.
nvicDisableVector(RP_USBCTRL_IRQ_NUMBER);
#endif
osalSysUnlock();
return msg;
}