qmk-dactyl-manuform-a/keyboards/cannonkeys/db60
Ryan 9dcd03b6ca
Set `BOOTLOADER = stm32-dfu` for all applicable STM32 boards (#12956)
* Set bootloader to stm32-dfu for STM32F303

* Set bootloader to stm32-dfu for STM32F0x2

* Set bootloader to stm32-dfu for STM32F4x1

* Set bootloader to stm32duino for sowbug

* Delete redundant bootloader_defs headers

* Add some missing MCU name comments

* Move APM32 dfu-suffix overrides underneath bootloader

* Remove redundant STM32_BOOTLOADER_ADDRESS defines/rules
2021-06-08 19:48:46 +10:00
..
hotswap Some fixes for the Bakeneko variant DB60s (#12662) 2021-05-12 10:52:15 +10:00
j02 Some fixes for the Bakeneko variant DB60s (#12662) 2021-05-12 10:52:15 +10:00
keymaps Some fixes for the Bakeneko variant DB60s (#12662) 2021-05-12 10:52:15 +10:00
rev2 Some fixes for the Bakeneko variant DB60s (#12662) 2021-05-12 10:52:15 +10:00
chconf.h ChibiOS conf migrations... take 11 (#11646) 2021-01-21 17:00:53 +11:00
config.h Fix up WS2812 SPI driver on F072. (#13022) 2021-06-03 09:48:16 +10:00
db60.c
db60.h Some fixes for the Bakeneko variant DB60s (#12662) 2021-05-12 10:52:15 +10:00
halconf.h Fix up comments showing how to execute config migration. (#11621) 2021-01-20 02:19:36 +11:00
info.json
mcuconf.h Fix up comments showing how to execute config migration. (#11621) 2021-01-20 02:19:36 +11:00
readme.md Some fixes for the Bakeneko variant DB60s (#12662) 2021-05-12 10:52:15 +10:00
rules.mk Set `BOOTLOADER = stm32-dfu` for all applicable STM32 boards (#12956) 2021-06-08 19:48:46 +10:00

readme.md

CannonKeys DB60

DB60 "Daughterboard 60" Keyboard

  • Keyboard Maintainer: Andrew Kannan
  • Hardware Supported: STM32F072CBT6 (or equivalent)

Make example for this keyboard (after setting up your build environment):

make cannonkeys/db60/rev2:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Some notes about the versions: The original DB60 was shipped with the J-02. To build that, you will need to use the following command:

make cannonkeys/db60/j02:default

Solderable DB60s were shipped with keyboards after the J-02. This variant has cutouts along the top and bottom to support O-ring gasket mounting. To build these, you can use this command:

make cannonkeys/db60/rev2:default

Hotswap ANSI DB60s were shipped with the Bakeneko keyboards from CannonKeys. These also have the o-ring gasket mounting points. To build this:

make cannonkeys/db60/hotswap:default