qmk-dactyl-manuform-a/keyboards/edda
Ryan c12b997679
Tidy up `SLEEP_LED_ENABLE` rules (#15362)
2021-12-01 21:13:00 +11:00
..
keymaps [Keyboard] Add Edda Keyboard (#13953) 2021-08-12 06:59:07 -07:00
config.h [Keyboard] Add Edda Keyboard (#13953) 2021-08-12 06:59:07 -07:00
edda.c [Keyboard] Add Edda Keyboard (#13953) 2021-08-12 06:59:07 -07:00
edda.h [Keyboard] Add Edda Keyboard (#13953) 2021-08-12 06:59:07 -07:00
info.json Remove width, height and key_count from info.json (#14274) 2021-09-12 14:04:56 +10:00
readme.md [Keyboard] Add Edda Keyboard (#13953) 2021-08-12 06:59:07 -07:00
rules.mk Tidy up `SLEEP_LED_ENABLE` rules (#15362) 2021-12-01 21:13:00 +11:00

readme.md

Edda PCB

Alice layout PCB with top mounted USB C used in Mekanisk Edda

Make example for this keyboard (after setting up your build environment):

make edda:default

Flashing example for this keyboard:

make edda:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

How to enter bootloader (DFU):

Press and hold the button on the keyboard (the small one on the same side as the MCU) for more than 1 second. The keyboard will then enter bootloader (DFU) mode and it's ready to flash the firmware.
Note: If holding the button a shorter time, the keyboard will just reset. If you want to exit bootloader mode without flashing a firmware, disconnect the keyboard from your PC and reconnect it.