qmk-dactyl-manuform-a/keyboards/gh60/satan
Ryan 0b37e07f90
Remove redundant `MIDI_ENABLE = no` in keyboard-level rules.mk (#14649)
2021-09-30 19:17:20 +10:00
..
keymaps Remove redundant `MIDI_ENABLE = no` in keyboard-level rules.mk (#14649) 2021-09-30 19:17:20 +10:00
config.h Remove `DESCRIPTION`, E-G (#11574) 2021-01-18 12:49:25 +11:00
info.json Remove width, height and key_count from info.json (#14274) 2021-09-12 14:04:56 +10:00
readme.md
rules.mk Remove redundant `UNICODE_ENABLE = no` in keyboard-level rules.mk (#14633) 2021-09-30 08:14:21 +10:00
satan.c Refactor to use led config - Part 5 (#10975) 2020-11-21 19:11:24 +00:00
satan.h

readme.md

Satan GH60

A clone of the GH60 60% keyboard, with full backlighting support.

Keyboard Maintainer: QMK Community
Hardware Supported: Satan GH60 PCB
Hardware Availability: https://www.1upkeyboards.com/shop/controllers/gh60-satan-pcb/

Make example for this keyboard (after setting up your build environment):

make gh60/satan:default

Note: This GH60 Satan firmware will not be compatible with the GH60 Rev C PCB. Conversely, the GH60 Rev C firmware will not be compatible with this PCB. Please ensure you have the correct firmware/pcb combination before flashing.

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

RGB Underglow (WS2812B LED Strip)

This board also supports underglow with a slight mod.

Connect the DIN pad of the LED strip to PE2 on the ATmega32U4, like so:

controller

Then connect VCC and GND to pins 1 and 6 at the bottom of the PCB:

power

ISP Header

If you want to flash another bootloader (such as QMK-DFU), or can't get into the bootloader in the first place, the row of pins at the bottom can be used to ISP flash the board:

1 2 3 4 5 6 7
VCC MISO SCK MOSI RESET GND NC