andrejl
/
qmk-dactyl-manuform-a
1
0
Fork 0
Code Issues Pull Requests Projects Releases Wiki Activity
qmk-dactyl-manuform-a/keyboards/kinesis/stapelberg
History
Ryan 41c50bb653
Change keyboard level include guards to `pragma once` (#14248) 
* Change keyboard level include guards to `pragma once`

And clean up a lot of layout macros

* Oops

* Remove dangling endif
 		2021-09-01 19:03:14 +10:00
..
config.h Change keyboard level include guards to `pragma once` (#14248) 2021-09-01 19:03:14 +10:00
readme.md [Keyboard] Update Stapelberg readme.md (#5557) 2019-09-20 23:59:16 -07:00
rules.mk Cleanup rules.mk for 32U4 keyboards, I-K (#7097) 2019-10-21 21:43:18 -07:00
stapelberg.c Refactor to use led config - Part 5 (#10975) 2020-11-21 19:11:24 +00:00
stapelberg.h Change keyboard level include guards to `pragma once` (#14248) 2021-09-01 19:03:14 +10:00

readme.md

kinesis_stapelberg keyboard firmware

This folder contains the firmware customization required to run QMK on the custom controller for the Kinesis Advantage created by Michael Stapelberg. It differs from the alvicstep keyboard in that the existing QMK Kinesis Advantage project uses the existing controller board provided by Kinesis.

The controller board hardware is described here

Mapping the pin assignments was done using the corresponding matrix description provided at this link

This code makes no attempt to drive the four LEDs provided on the controller board.

Building the Hardware

If you want to perform this customization, these parts may be helpful.

Function Quantity Vendor Part Number
13 pin connector for function keys and finger keywells 4 Digi-Key WM14526-ND
10 pin headers for thumb clusters 4 Digi-Key 609-3250-ND
8 pin cable for thumb clusters 2 Digi-Key SAM8928-ND
Teensy++ 2.0 1 Digi-Key 1528-1056-ND
2 pin right angle header for reset 1 Digi-Key 952-2244-ND
Reset cables 1 Digi-Key PRT-08672-ND

The board and connections are shown here controller board

The Teensy mounting detail can be seen here. I used a socket for prototyping. teensy detail

Since the proper mounting of the Teensy board places the reset button in a tight space, I added a 2-pin header to the reset and ground pins on the edge of the board. Shorting these two pins together will reset the board. I also put female to male header jumper cables on these so they could be accessed outside the enclosure. The exterior cables can be seen here. exterior reset

Keymaps

Default

To build with the default keymap, run make kinesis/stapelberg while in the QMK directory.

Dvorak

This keymap contains a dvorak implementation as well as media and symbol layers.

Run make kinesis/stapelberg:dvorak while in the QMK directory.