qmk-dactyl-manuform-a/keyboards/bpiphany/ghost_squid
Ryan a8d440e4e0
Tidy up NKRO_ENABLE rules (#15382)
2021-12-09 16:05:44 +11:00
..
keymaps/default
config.h
ghost_squid.c
ghost_squid.h
matrix.c
readme.md
rules.mk Tidy up NKRO_ENABLE rules (#15382) 2021-12-09 16:05:44 +11:00

readme.md

Ghost Squid Controller

This is the firmware for Rev. 20140518 of the Ghost Squid controller by Bathroom Epiphanies, a replacement controller for the Cooler Master Quick Fire XT.

The code was adapted from the BathroomEpiphanies QMK Firmware.

  • Keyboard Maintainer: QMK Community
  • Hardware Supported: Ghost Squid
  • Hardware Availability: 1upkeyboards

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Keycode in layout: Press the key mapped to RESET if it is available

Make example for this keyboard (after setting up your build environment):

104 key default layout:

make bpiphany/ghost_squid:default

Flashing example for this keyboard:

make bpiphany/ghost_squid:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.