cgitemplate is a modified misctemplate that takes an optional cgi object
and uses it to set the baseurl, and also optionally the forcebaseurl,
if a page is provided.
If no cgi object is provided, it will fall back to using $config{url}.
I expect this will only be needed in exceptional cases where
that doesn't much matter, such as cgierror().
showform uses cgitemplate, so there is no more need for showform_preview.
Everywhere that REMOTE_ADDR was used, a session object is available, so
instead use its remote_addr method.
In IkiWiki::Receive, stop setting a dummy REMOTE_ADDR.
Note that it's possible for a session cookie to be obtained using one IP
address, and then used from another IP. In this case, the first IP will now
be used. I think that should be ok.
Since all forms are wrapped in a template that defines the actual
stylesheets, formbuilder just has to be told to turn on stylesheet mode,
not what file is the style sheet.
Problem here was that no charset http header was being sent.
I fixed this globally by making cgi_custom_failure send the header.
Required changing its parameters.
When redirecting to a page, ie, after editing, ensure that the url is
uri-encoded. Most browsers other than MSIE don't care, but it's the right
thing to do.
The known failure case involved editing a page that had utf-8 in the name
using MSIE.
This is likely a misconfiguration and can cause login to fail as the
browser refuses the send the session cookie back over http.
Not entirely happy with putting the check where I did, since users have to
try to log in, and fail, to see the misconfiguration explained. But I could
not find a better place to put the check.
This redirects to the given page (or if none is given, the page parameter
given to the CGI), or displays an error with a create link if the page
doesn't exist.
A new ikiwiki-transition moveprefs subcommand can pull the old data out of
the userdb and inject it into the setup file.
Note that it leaves the old values behind in the userdb too. I did this
because I didn't want to lose data if it fails writing the setup file for
some reason, and the old data in the userdb will only use a small amount of
space. Running the command multiple times will mostly not change anything.
The constructor can fail with a useless error message if module fail to
load. Work around this by evaling it, and checking for failures, and
printing CGI::Session->errstr to get a more useful message.
Joey Hess
Simon McVittie
Joey Hess
Jonas Smedegaard
Simon McVittie
Joey Hess