qmk_firmware/keyboards/handwired/3dortho14u

3dortho14u

A symmetrical 14u wide ortholinear keyboard.

In addition to the 3d printed parts and microcontroller, the following hardware is required:

• 8 * 12 mm M3 bolt
• Either:
  • 8 * M3 muts and CA glue OR
  • 8 * 3x3 mm threaded insert
• Optional:
  • USB daughter board

---

• Keyboard Maintainer: xia0
• Hardware Supported:
  • rev1: Teensy 2.0 (ATmega32u4)
  • rev2: Arduino Pro Micro (ATmega32u4)
• Hardware Availability: github

Make example for this keyboard (after setting up your build environment):

make 3dortho14u/rev1:default

Flashing example for this keyboard:

make 3dortho14u/rev1:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to RESET if it is available