updated readme with images

master
SethSenpai 2016-10-03 18:27:52 +00:00
parent 0f06e94d5d
commit 0e2786e396
1 changed files with 9 additions and 1 deletions

View File

@ -16,7 +16,15 @@ Firmware was build for use with a Pro Micro based on a ATMEGA32u4 at 16mHz.
The indicator LED's are normally assigned to `pin C6` and `pin D4`, C6 goes high when the first layer is used, D4 goes high when layer 2 is used. Both LED's are off when the default layer is enabled. The indicator LED's are normally assigned to `pin C6` and `pin D4`, C6 goes high when the first layer is used, D4 goes high when layer 2 is used. Both LED's are off when the default layer is enabled.
'+' of the LED goes to the respective pins and can be joined together on the '-' into a resistor that runs to the ground pin of the pro micro. With a standard LED a resistor value of 100 ohm is fine, keep in mind that you cannot use high powered LEDS on these pins without ruining your pro micro. '+' of the LED goes to the respective pins and can be joined together on the '-' into a resistor that runs to the ground pin of the pro micro. With a standard LED a resistor value of 100 ohm is fine, keep in mind that you cannot use high powered LEDS on these pins without ruining your pro micro.
Schematic of the build is coming soon. ## schematic of the switches and diodes
![schematic overview](http://i.imgur.com/fleitoA.jpg)
Keep in mind that the minus of the diodes should point towards the pro micros inputs.
##LED hookup
![led overview](http://i.imgur.com/U6m865n.jpg)
## Adding more layers ## Adding more layers